![]() There is a library for setting various low power modes in arduino. So first download and install the library from the given link and use the above code to put the Arduino in Idle Sleep Mode. Arduino can be waked up any time by using external or internal interrupt.Īrduino Code for Idle Sleep Mode: LowPower.idle(SLEEP_8S, ADC_OFF, TIMER2_OFF, TIMER1_OFF, TIMER0_OFF, SPI_OFF, USART0_OFF, TWI_OFF) Idle mode basically stops the CLK CPU and CLK FLASH. This mode stops the CPU but allow the SPI, 2-wire serial interface, USART, Watchdog, counters, analog comparator to operate. Then the sleep mode select bits select the sleep mode among Idle, ADC noise reduction, Power-Down, Power-Save, Standby and External Standby.Īn internal or external Arduino interrupts or a Reset can wake up the Arduino from the sleep mode.įor entering into the Idle sleep mode, write the SM bits of the controller ‘000’. Arduino UNO, Arduino Nano and Pro-mini comes with ATmega328P and it has a Brown-out Detector (BOD) which monitors the supply voltage at the time of sleep mode.įor entering into any of the sleep mode we need to enable the sleep bit in the Sleep Mode Control Register (SMCR.SE). Sleep Modes allow the user to stop or turn off the unused modules in the Microcontroller which significantly reduce the power consumption. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |